Loading... Please wait...

Our Newsletter

Photovac MicroFID Flame Ionization Detector (Service)

  • Image 1
0.00 LBS
Calculated at checkout

Product Description

Maintenance, Service, Repair, Photovac  MicroFID Flame Ionization Detector

Disassemble and Clean Pump

Replace Internal Tubing

Disassemble and Clean Detector

Check Igniter Plug Condition and Operation

Battery Load Test and Cell Check

Reassemble above listed Components

H2 Flow Check

Pump Suction Test

Full Operation Check

Firmware Update if Applicable

Calibrate to Factory Specifications


This service will correct the following FID Failures or Issues: Contaminated Detector, Poor Suction, Failure to Ignite, Flame-Out Issues. This service will also address both of the following “Check” Errors; Signal from Zero Gas Too High and Signal from Span Gas Too Low or High. (As long as current, certified calibration gas is being used).

Your MicroFID will be evaluated upon receipt and you will be contacted within 48 hours if additional parts or service is required. This Service DOES NOT cover the cost of failing parts or components. These items, if necessary, will be quoted separately.

Peterson Environmental, Inc. has serviced environmental instrumentation for 10 Years with many satisfied customers. All of our services come with a 30 Day satisfaction guarantee.

After you make your purchase you will be contacted via email and given shipping instructions.

Find Similar Products by Category

Add to Wish List

Click the button below to add the Photovac MicroFID Flame Ionization Detector (Service) to your wish list.

You Recently Viewed...